Precautions for installation and maintenance of fire hose

Release time:


1. When the fire hose is put on the fire hose interface, it must be carefully screwed in and then tied firmly.
2. Check whether the fire hose and joint are in good condition. If there is any damage, it is strictly prohibited to use it.
3. The fire hose shall be connected to the place close to the water pump. The fire hose filled with water shall be prevented from twisting or bending suddenly. At the same time, the buckle of the fire hose shall be prevented from collision and damage.
4. When using the fire hose, the belt body must be flat, not twisted, not heavy pressure with sharp tools, hard dragging and hard pulling. Prevent belt body breakage.
5. After using liquids such as acid and alkali, it should be rinsed immediately to protect the adhesive layer to prevent corrosion of the belt body and affect the service life.
6. After the fire hose is used, it must be dried in the sun or air-dried and then rolled for storage to prevent the hose from leaving the accumulated water and affecting the use of the lining.
7. The fire hose is placed in a ventilated and dry place, and cannot be placed outdoors in the sun and rain or where the temperature is too high, humid, and corrosive, so as not to cause the hose to age or the lining edge to stick together, affecting normal use.